Install The Carriage Assembly, Carriage Belt, And The Frame Tensioner - ENCAD NovaJet 800 Series Service Manual

Install the Carriage Assembly, Carriage Belt, and the Frame Tensioner

1. To install the Belt onto the right Carriage, the "bumps" on the belt
(where the ends of the belt are joined together to make the belt
continuous) must be positioned between the left and right posts of the
Belt Clamp. See Figure 5-17.
2. Slide the Carriage Belt between the right post and the middle post and
guide it down into the Belt Clamp. Then slide the Carriage Belt
between the left post and the middle post and finish placing the
Carriage Belt into the Belt Clamp.
3. Check the position of the Carriage Belt to make sure it matches
Figure 5-17.
4. Make sure the left end of the Trailing Cables extends out beyond the
left end of the Trailing Cable Support Assembly.
5. Position and hold into place the Carriage Coupler onto the right
Carriage. See Figure 5-18.
6. Slide the right Carriage onto the left end of the Slide Shaft, making
sure that the Encoder Strip fits into the slot in the Slider and the
Figure 5-18. Carriage Coupler Installation.
NovaJet 800 Series Service Manual
Assembly\Disassembly 5-28