Green Fpga Fan (Fan 6) - Christie CP42LH Service Manual

3. Remove the 2 screws securing fan #5 to the mounting bracket.
4. Lift the fan up and out of the projector.

Green FPGA fan (fan 6)

Estimated replacement time: 20 minutes
Fan #6 provides cooling to the green satellite card in
the light engine compartment.
1. Remove the Light
2. Disconnect the fan #6 inline connector and free
from routing clips.
3. Remove the 2 screws securing fan #6.
4. Lift out the fan.
Card cage exhaust fans (fans 6 and 8)
Estimated replacement time: 18 minutes per fan
The card cage fans are mounted below the card cage.
1. Remove the Card cage
2. Loosen the 2 screws securing the fan compartment cover plate to the base of the projector.
3. Slide the cover plate off the base plate.
4. Remove the 4 screws securing the fan assemblies to the base.
5. Cut the cable tie securing the fan harnesses.
6. Disconnect the defective fan inline connector.
7. Pull the defective fan away from the rubber isolators.
Card cage intake fans (fans 9, 10, 11)
Estimated replacement time: 4 minutes per fan
The card cage fans are on top of the card cage and push cool air into the electronic card cage.
1. Remove the Front top
CP42LH Service Manual
020-101686-03 Rev. 1 (08-2016)
engine, see page 58.
assembly, see page 70.
lid, see page 41.
Parts and Module Replacement
54