Rear Right Skin (Ignitor/Blower Compartment) - Christie CP2230 Service Manual

5.5.3 Rear Right Skin (ignitor/blower compartment)

The rear right skin is held in pace by three captive
screws. Removing this skin provides access to the
igniter, lamp blower, lamp blower interlock,
LVPS and AC relay.
(Estimated Replacement Time: 2 minutes)
1. Using a #2 Phillips
screws. (Figure 5-3)
2. Lift the skin up and out to remove.
5.5.4 Touch Panel Controller (TPC)
The TPC is located at the back of the projector. It is
attached to a ball-joint mount which allows it to be
viewed at any angle. The TPC can also be removed and
be held by the operator. The TPC provides a user friendly
interface that runs off a fully integrated Windows XP-
based operating system.
(Estimated Replacement Time: 4 minutes)
1. Disconnect the TPC harness from the connector on
the projector's back cover.
2. Loosen the TPC mounting arm just enough to
remove the TPC assembly from the ball joint at the
back of the projector.
3. When replacing, repeat instructions in reverse. Check the main switch on the back of the TPC to ensure it
is in the ON position. (Figure 5-4)
5.5.5 Rear Skin
(Estimated Replacement Time: 4 minutes)
1. Remove the TPC. Refer to
(TPC), on page
2. Using a #2 Phillips
the back cover to the chassis. (Figure 5-5)
3. Tilt and lift the back cover just enough for the bottom
tabs to clear the frame and remove.
4. When reinstalling, align the bottom tabs and reverse the
above instructions.
CP2230 Service Manual
020-100562-06 Rev. 1 (05-2016)
, loosen the three captive
™
5.5.4 Touch Panel Controller
5-7.
, loosen the three screws securing
™
Section 5: Parts and Module Replacement
Figure 5-3 Rear Right Skin
Figure 5-4 TPC
Figure 5-5 Remove Back Cover
5-7