Installing The Instrument - YOKOGAWA DL7440 User Manual

3.2

Installing the Instrument

Installation Conditions
IM 701450-01E
To avoid danger, never use the instrument with the rear panel facing down, as
the cooling vents will be obstructed.
Install the instrument in a place that meets the following conditions.
Flat, Even Surface
Install the instrument with the correct orientation on a stable, horizontal surface. The
recording quality of the printer (optional) may be hindered when the instrument is used in
an unstable place.
Well-Ventilated Location
Inlet holes are located on the top and bottom of the instrument. In addition, there are
exhaust holes for the cooling fan on the rear panel. To prevent internal overheating,
allow for enough space around the instrument (see the figure below) and do not block
the inlet and exhaust holes. If a printer comes with your DL7400, allow extra space for
operation and do not place objects on top of the printer.
10 cm or more
5 cm or
more
WARNING
5 cm or
more
3
10 cm or
more
3-3