5.9
Using the Linear Scaling Function
Procedure
VERTICAL
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
IM 701450-01E
TRIGGER
HORIZONTAL
TRIG D
SEARCH
ACTION
PRESET
ZOOM
MODE
V/DIV
TIME/DIV
SIMPLE
ENHANCED
DELAY
POSITION
LOGIC
SNAPSHOT
CLEAR TRACE
HELP
1.
Press one of the CH1 to CH8/4 keys to select the channel. The CH menu
appears.
You can select up to channel CH4 and CH8 on the DL7440 and DL7480, respectively.
2.
Press the Next (1/2) soft key
3.
Press the Linear Scale AX+B soft key to select ON.
4.
Press the A/B soft key to set the jog shuttle control to A.
5.
Turn the jog shuttle to set the A value.
6.
Likewise, set the B value.
7.
To attach a unit, press the Unit soft key to display the keyboard and enter the
unit name.
Note
•
Linear scaling is not available for the following waveforms.
•
Snapshot waveforms
•
Accumulated waveforms (however, linear scaling is possible on the accumulated
waveform acquired last.)
•
Linear scaling is set for each channel.
•
The scaling coefficient A and offset value B that you entered are held even if you turn OFF
the linear scaling function.
•
Computation is performed using the linear scaling results.
<For a description of this function, refer to page 2-4.>
• To exit the menu during operation, press ESC located
above the soft keys.
• For a description of the operation using a USB keyboard or
a USB mouse, see section 4.3.
5
5-15