Making Cursor Measurements - YOKOGAWA DL7440 User Manual

10.5 Making Cursor Measurements

Procedure
X-Y
SETUP DISPLAY
MEASURE CURSOR
MENU MENU
PRINT IMAGE SAVE
HISTORY
Measuring Waveforms Using Horizontal Cursors
Selecting the Horizontal Cursor
IM 701450-01E
FILE MISC RESET SELECT
PHASE
GO/NOGO MATH
SHIFT
ACQ START/STOP
Cursors can be placed on the displayed waveform (within the display record length, see
appendix 1) and various types of measured values at the cross point of the cursor and
waveform can be displayed. The following four types of cursors are available. For the
setup procedures of each type, see the pages indicated below.
• Horizontal cursors -> Page 10-33
• Vertical cursors -> Page 10-35
• Marker cursors -> Page 10-37
• Angle cursors -> Page 10-39
1. Press CURSOR. The CURSOR menu appears.
2. Press the Type soft key. The Type menu appears.
3. Press the Horizontal soft key.
<For a description of this function, refer to page 2-29.>
• To exit the menu during operation, press ESC located
above the soft keys.
• In the procedural explanation below, the term
jog shuttle & SELECT refers to the operation of
selecting/setting items and entering values using the
jog shuttle and SELECT and RESET keys. For details
on this operation, see sections 4.1 or 4.2.
• For a description of the operation using a USB keyboard
or a USB mouse, see section 4.3.
When X-Y waveforms are
not displayed
When X-Y waveforms are
displayed
10-33
10