Performing Statistical Processing Of The Measured Values Of Waveform Parameters - YOKOGAWA DL7440 User Manual

10.7 Performing Statistical Processing of the
Measured Values of Waveform Parameters
Procedure
SETUP
MEASURE
MENU
PRINT
HISTORY
Measuring Waveform Parameters and Performing Statistical Processing (Normal
Statistical Processing)
10-54
X-Y
DISPLAY FILE MISC RESET
PHASE
CURSOR GO/NOGO MATH
MENU
IMAGE SAVE SHIFT
ACQ START/STOP
1. Press MEASURE. The MEASURE menu appears.
2. Press the Mode soft key. The Mode menu appears.
3. Press the Statistics soft key. The waveforms are measured and statistical
processing is performed. Then, statistics are displayed.
4. Perform the following setup procedures as necessary. For the operating
procedure, see section 10.6.
• Selecting the measurement parameters (steps 4 to 8 on page 10-46).
• Setting the delay measurement between waveforms (steps 9 to 18 on page
10-47).
• Turning ON/OFF 1 cycle mode (step 19 on page 10-48).
• Setting the measurement range (steps 20 and 21 on page 10-48).
• Setting distal, mesial, and proximal values (steps 22 to 31 on page 10-48).
• Setting high and low values (step 32 on page 10-49).
<For a description of this function, refer to page 2-30.>
• To exit the menu during operation, press ESC located
SELECT
above the soft keys.
• For a description of the operation using a USB keyboard or
a USB mouse, see section 4.3.
Display example of statistics
IM 701450-01E