Changing The Scsi Id Number - YOKOGAWA DL7440 User Manual
Digital oscilloscope
Hide thumbs
Also See for DL7440:
- User manual (55 pages) ,
- User manual (176 pages) ,
- Operation manual (29 pages)
Table of Contents
Advertisement
12.4 Changing the SCSI ID Number
Procedure
SETUP
MEASURE
MENU
PRINT
HISTORY
Explanation
SCSI ID Numbers
12-8
X-Y
DISPLAY
FILE
MISC
RESET
PHASE
CURSOR
GO/NOGO
MATH
MENU
IMAGE SAVE
SHIFT
ACQ
START/STOP
1.
Press MISC. The MISC menu appears.
2.
Press the SCSI ID soft key. The SCSI ID menu appears.
3.
Turn jog shuttle to select 0 to 7.
4.
Press the Initialize SCSI soft key. The SCSI ID is changed to the selected ID
number. The SCSI icon at the upper right corner of the screen blinks while the
change is in progress. When the change is complete, the icon disappears.
The SCSI ID number is used to distinguish between the various devices connected to
the SCSI chain. Make sure not to use duplicate ID numbers on any of the connected
devices.
Own ID (the ID of the DL7400) can be set in the range from 0 to 7. The default setting is 7.
Note
•
Do not set the SCSI ID number of the external SCSI device to the same ID number as the
DL7400.
•
When changing the SCSI ID number, make sure to press the Initialize SCSI soft key.
•
The SCSI ID numbers of external SCSI devices are automatically detected when the
DL7400 is turned ON.
•
If you change the ID number, be sure to execute Initialize SCSI to detect the new SCSI ID
number.
• To exit the menu during operation, press ESC located
SELECT
above the soft keys.
• For a description of the operation using a USB keyboard or
a USB mouse, see section 4.3.
IM 701450-01E
Advertisement
Table of Contents
