Video Signal Output (Video Out (Vga)) - YOKOGAWA DL7440 User Manual

14.3 Video Signal Output (VIDEO OUT (VGA))

Video Signal Output Connector
Connecting to the Monitor
IM 701450-01E
• Connect the cable after turning OFF the DL7400 and the monitor.
• Do not short the VIDEO OUT (VGA) terminal or apply external voltage to it.
Doing so can cause damage to the DL7400.
The DL7400 display can be output to a monitor through the RGB output. Connectable
monitors are VGA monitors or multi-sync monitors capable of displaying VGA.
Pin No. Signal Name
1 Red
2 Green
3 Blue
4 –
5 –
6 GND
7 GND
8 GND
9 –
10 GND
11 –
12 –
13 Horizontal sync signal
14 Vertical sync signal
15 –
10
VIDEO OUT
(VGA)
D-Sub 15-pin receptacle
1. Turn OFF the DL7400 and the monitor.
2. Connect the DL7400 and the monitor using an analog RGB cable.
3. The screen of the DL7400 appears on the monitor when both the DL7400 and
the monitor are turned ON.
Note
• The RGB video signal is constantly output from the VIDEO OUTPUT terminal.
• The monitor screen may flicker if the DL7400 or another instrument is brought close to the
monitor.
• The edge of the screen may drop out depending on the monitor type.
CAUTION
Specifications
0.7 Vp-p
0.7 Vp-p
0.7 Vp-p
Approx. 31.3 kHz, TTL negative logic
Approx. 60 Hz, TTL negative logic
5 1
6
15 11
14
14-5