Performing User-Defined Computation (Optional) - YOKOGAWA DL7440 User Manual

9.9 Performing User-Defined Computation
(Optional)
Procedure
X-Y
SETUP DISPLAY
MEASURE CURSOR
MENU MENU
PRINT IMAGE SAVE
HISTORY
Entering User-Defined Computation Mode
Turning ON/OFF the Computed Waveforms
Setting the Equation, Scaling, Unit, and Label
IM 701450-01E
FILE MISC RESET SELECT
PHASE
GO/NOGO MATH
SHIFT
ACQ START/STOP
Note
Steps 3 to 7 describe the setup procedures for computed waveform Math1. Perform similar
steps for Math2.
1. Press MATH. The MATH menu appears.
2. Press the Math Mode soft key to select User. The user-defined computation
menu appears.
If you select Normal, normal computation mode is enabled. For a description of the
procedure, see sections 9.1 to 9.8.
3. Press the Math1 Display soft key to select ON or OFF.
• If ON is selected, the Math1 waveform is displayed.
• If OFF is selected, the Math1 waveform is not displayed.
4. Press the Math1 User Define Setup soft key. The Math1 User Define Setup
dialog box opens.
<For a description of this function, refer to page 2-23.>
• To exit the menu during operation, press ESC located
above the soft keys.
• In the procedural explanation below, the term
jog shuttle & SELECT refers to the operation of
selecting/setting items and entering values using the
jog shuttle and SELECT and RESET keys. For details
on this operation, see sections 4.1 or 4.2.
• For a description of the operation using a USB keyboard
or a USB mouse, see section 4.3.
9
9-19