Chapter 9 Waveform Computation; Entering Normal Computation Mode, Displaying Computed Waveforms, And Assigning Labels To Computed Waveforms - YOKOGAWA DL7440 User Manual

Chapter 9 Waveform Computation

9.1 Entering Normal Computation Mode,
Displaying Computed Waveforms, and
Assigning Labels to Computed Waveforms
Procedure
X-Y
SETUP DISPLAY
MEASURE CURSOR
MENU MENU
PRINT IMAGE SAVE
HISTORY
Entering Normal Computation Mode
Turning ON/OFF the Computed Waveforms
IM 701450-01E
FILE MISC RESET SELECT
PHASE
GO/NOGO MATH
SHIFT
ACQ START/STOP
Note
Steps 3 to 5 describe the setup procedures for computed waveform Math1. Perform similar
steps for Math2.
• If the user-defined computation option is installed, start from step 1. You must first
enter normal computation mode.
• If the user-defined computation option is not installed, start from step 3.
If the user-defined computation option is installed, select normal computation mode.
1. Press MATH. The MATH menu appears.
2. Press the Math Mode soft key to select Normal. The normal computation menu
appears.
If you select User, user-defined computation mode is enabled. For a description of the
procedure, see section 9.9.
3. Press the Math1 Display soft key to select ON or OFF.
• If ON is selected, the Math1 waveform is displayed.
• If OFF is selected, the Math1 waveform is not displayed.
When the user-defined
computation option is installed
• To exit the menu during operation, press ESC located
above the soft keys.
• In the procedural explanation below, the term
jog shuttle & SELECT refers to the operation of
selecting/setting items and entering values using the
jog shuttle and SELECT and RESET keys. For details
on this operation, see sections 4.1 or 4.2.
• For a description of the operation using a USB keyboard
or a USB mouse, see section 4.3.
9
9-1