DISASSEMBLY/REASSEMBLY (Continued)
5.2
5.2.3 Separating Rear Case from Chassis
Assembly
1. Remove four (
washers) attaching Rear Case to
chassis assembly.
2. Separate Rear Case from Front Case by
pulling Rear Case away from chassis
assembly.
) screws (and associated
4
Rear Case Assembly
CORRECTIVE MAINTENANCE
During Reassembly:
• Ensure Silicone Tubing gasket in Rear
Case is in place and undamaged. (See
Figure
)
7A-12
• Raise Drive Head to highest position
before sliding Chassis Assembly into
Rear Case.
• Ensure wiper assembly seals between
cutout in rear case.
Chassis Assembly
Alaris
Syringe Module (8110 Series)
®
Alaris
PCA Module (8120 Series)
®
Technical Service Manual
Syringe Module
5A-5