Intended Use The Docking Station is intended to be used to provide mounting and power support to the Alaris® Infusion Pumps range within the operating environment specified in this Directions For Use (DFU). In such environments, the device may be exposed to the following range of therapies: Fluid therapy, blood transfusions, parenteral feeding, drug therapy, chemotherapy, dialysis and anaesthesia.
Potential symbols used). Power tile Equalisation (PE) Connector ON/OFF switch Mains inlet See Operating Precautions and Specifications for the maximum number of Alaris® Infusion Pumps permissible when used with a trolley. 1000DF00653 Issue 2 3/16...
Alaris® DS Docking Station Symbol Definitions Symbol Definitions Labelling Symbols Symbol Description Consult accompanying documents Potential Equalisation (PE) Connector IPX1 Protected against vertically falling drops of water Alternating Current Device complies with the requirements of Council Directive 93/42/EEC as amended by 2007/47/EC.
CareFusion, is at your sole risk, and CareFusion does not provide any warranty for or endorsement on any Alaris® DS Docking Station that has been so modified or altered. CareFusion’s product warranty shall not apply in the event the Alaris®...
Where appropriate, mitigations identified and implemented. • The Docking Station should only be used with compatible CareFusion products and accessories and appropriate infusion bags and lines. • While being used for patient therapy, each Docking Station should be dedicated to the care of a single patient.
1. Check that the Docking Station is complete, undamaged and that the voltage rating specified on the label is compatible with your AC power supply. 2. Items supplied are: • Alaris® DS Docking Station • Directions For Use • Protective Packaging Power Input The Docking Station has its own power distribution circuit.
Getting Started Fitting an Alaris® Infusion Pump Rectangular bar Release lever (push to release) Rotating cam See Operating Precautions and Specifications for the maximum number of Alaris® Infusion Pumps permissible when used with a trolley. Rotating Release lever (push Rectangular bar to release) The rotating cam can be fitted to the rectangular bar on the Docking Station.
Alaris® DS Docking Station Getting Started Fitting the Docking Station to the Trolley 1. Fix the mounting kits to the vertical extrusion of the Docking Station. 2. Fit the top and bottom mounting bracket of the Docking Station to the trolley, adjust spacing to suit trolley, and tighten to ensure the Docking Station is secure.
Alaris® DS Docking Station Getting Started Transporting the Docking Station on a trolley with optional poles fitted When moving a trolley between locations, mounted with the Docking Station and with the optional poles fitted, it is important that the instructions below are followed.
All preventative and corrective maintenance and all such activities shall be performed at a compliant work place in accordance with the information supplied. CareFusion will not be responsible should any of these actions be performed outside the instructions or information supplied by CareFusion.
Alaris® DS Docking Station Products and Spare Parts Products and Spare Parts Alaris® Infusion System Range of products in the Alaris® Infusion System product family are: Part Number Description 8002MED01 Alaris® GH Syringe Pump (with Plus software) 8002MED01-G Alaris® GH Guardrails® Syringe Pump (with Plus software) 8003MED01 Alaris®...
Alaris® DS Docking Station Service Contacts Service Contacts For service contact your local Affiliate Office or Distributor. CareFusion, CareFusion, CareFusion, CareFusion, PO Box 5527, Pascalstr. 2, The Crescent, Jays Close, 14B George Bourke Drive, Dubai, United Arab Emirates. 52499 Baesweiler,...
Page 17
Alaris® DS Docking Station Service Contacts Page Intentionally Left Blank 1000DF00653 Issue 2 16/16...
Need help?
Do you have a question about the Alaris and is the answer not in the manual?
Questions and answers