Disassembly/Reassembly; Required Materials, Supplies And Tools - Pca Module - CareFusion Alaris 8110 series Service Manual

CORRECTIVE MAINTENANCE
PCA Module
5.2

DISASSEMBLY/REASSEMBLY

Follow these procedures in order for the
most efficient disassembly of PCA Module
subassemblies. To reassemble the PCA
Module, reverse the disassembly steps.
CAUTION
Disconnect the PCA Module from the Alaris
System before attempting disassembly.
NOTE: Perform all maintenance on an
antistatic surface, preferably a grounded
antistatic mat.
Table 5B-1.

Required Materials, Supplies and Tools - PCA Module

NOTE: Contact/source information is subject to change.
• Silicone grease, Dow Corning Molykote
• Phillips screwdriver
#1
• Phillips screwdriver
#2
• Small diagonal cutters
• Lint-free cloth (such as, Kimwipes or lint-free tissue)
The following items are available from
• Hex Head Bit, /
1
16
• Power bit, ball hex
• Power bit, ball hex
• Tamper-resistant Torx bit, size T8,
• Torque screwdriver with a minimum range of
Micro-Adjustable,
• Torque wrench with a minimum range of
• Torx Bit, Size ,
T6
The following items may be purchased from McMaster-Carr (
• Insert-bit holder,
¼
• ¼" drive / " deep-well socket (available at any hardware or tool store)
9
16
• Slotted screwdriver,
• Insert-Bit, " Hex Size,
0.05
Setscrew)
5B-2
Alaris Syringe Module (8110 Series)
®
Alaris PCA Module (8120 Series)
®
Technical Service Manual
TECHNI-TOOL
, / " Length,
HX 1 TT #758SC0172
15
16
/ , , " length,
¼ HX 3½
5
64
/ , , " length,
¼ HX 3½
3
32
/
1
15
16
or
TT #844SC5002 TT #304TO034
/ " Length,
1 TT #758SC0301
15
16
" hex drive, " length,
6
/ " tip width, " length blade,
3
1
8
" Hex Shank,
¼
Before adhering gaskets and labels to the
instrument, clean the surface with a cotton
swab or soft cloth lightly dampened with
70%
CAUTION
To avoid the risk of electrical hazard or
®
damage to the instrument circuitry, do not
spray fluids directly onto the instrument or
allow fluids to enter the instrument.
, or equivalent (
33 http://www.dowcorning.com
(
800.832.4866
(used for
TT #758SC0172
TT #758SC0173
" length,
TT #758SC0321
- in-lbs. Recommend torque screwdriver,
3 15
.
in-lbs. Recommend
40
562.692.5911
#7225A42
#5682A37
" Length,
1 #8526A46
Isopropyl Alcohol.
; http://www.techni tool.com
–
" Park Position Collar Setscrew)
0.062
torque wrench
¼
; http://www.mcmaster.com
(used for " Park Position Collar
0.05
)
).
.
#155IE150
).