Chapter 6 - Troubleshooting; Introduction - CareFusion Alaris 8110 series Service Manual

NOTE: Replacing the Complete Housing
Assembly, Force Sensor Assembly, or Logic Board
Assembly in a module with version
software requires special calibration equipment.
Until version 7.1 or later is installed in the module,
these assemblies must be replaced at the depot.
Call CareFusion Technical Support
( ext.
800.854.7128 6003
information.
or earlier
7.0
) for assistance and
Chapter 6 — TROUBLESHOOTING
6.1

INTRODUCTION

This chapter describes possible problems
that can occur while using a Syringe or PCA
Module. Refer to this chapter before
attempting to service the module.
To facilitate troubleshooting when an
operating malfunction occurs, the Syringe
and PCA Modules alarm and display an
error message and/or error code. The
information in this chapter can help
diagnose and correct technical problems.
Use Maintenance Software to perform
applicable preventive maintenance,
calibration, and verification procedures.
Alaris
®
Alaris
Technical Service Manual
Syringe Module (8110 Series)
PCA Module (8120 Series)
®
6-1