1
4
3
4.4 Connect leakage ventilation
4.4.1 Connect leakage adapter using standard tapered connector
For leakage operation, an adapter is available as an option to allow tubes with sleeves with
an internal diameter of Ø 22 mm and a pressure-measuring tube with an internal diameter
≤ Ø 5 mm to be used. If the device is equipped with this adapter, proceed as follows to
connect the tube:
40
EN
Set up device
The pressure-measurement tube is the same length as
the ventilation tube and leads to the Y-connecting
piece where the ventilation tube and the exhalation
tube are brought together.
4. Connect the valve control tube (5) to the connection
2
of the device marked
The valve control tube leads straight from the patient
valve to the connection on the device and is therefore
shorter than the pressure measuring tube.
5. Connect the patient/ventilator interface, e.g. a mask.
It is essential to follow the instructions for use of the
5
patient/ventilator interface and of the patient circuit.
Proceed as follows to connect up the leakage circuit.
1. Plug the click adapter of the patient circuit onto the
ventilation outlet on the device.
2. Connect the patient/ventilator interface, e.g. a mask.
It is essential to follow the instructions for use of the
patient/ventilator interface and of the exhalation
system.
1. Push the ventilation tube onto the device outlet port
of the therapy device.
2. Now connect the pressure-measurement tube to the
connection on the device marked
3. Connect the patient/ventilator interface, e.g. a mask.
4. It is essential to follow the instructions for use of the
patient/ventilator interface and of the exhalation
system.
.
P
.