5.3 Activate/Deactivate Auto Switch-On - Weinmann VENTIlogic LS Instructions For Use Manual

On/Off key
The device starts to pump air through the patient circuit. The display switches to the default
display.
5.2.3 Displays on screen
Default display
4. To switch on the device, press the On/Off key
briefly. The device is now in ventilation mode. The
patient menu can be accessed via the menu key.
When Auto switch-on (only with leakage ventilation) is
activated, you can also put on the patient/ventilator
interface and switch on the therapy device by taking a
breath (see "5.3 Activate/deactivate Auto switch-on
(only leakage ventilation)" on page 52). The operating
hours and the Weinmann software version appear in the
display for about 3 seconds.
Ventilation parameters such as set therapy mode,
therapy pressures (CPAP pressure only in CPAP mode)
in hPa, the selected patient circuit and current
respiratory frequency in 1/min are shown in the
display.
Note: 1.01973 hPa correspond to 1 cm H
If softstart is activated, the softstart display
appears with the remaining softstart time, max. 30
minutes, or the max. softstart time (see "5.8 Set
softstart (in CPAP mode only)" on page 55) specified
by the doctor.
The bar chart shows the pressure curve for inspiration
and exhalation.
The respiratory phase change display shows whether
the current respiratory phase was triggered
spontaneously by the patient (
T
( ). Depending on respiratory phase, the display
switches from left (inspiration) to right (exhalation).
The illustration shows an exhalation triggered by the
machine.
O.
2
S
) or by the machine
EN
Operation
51