Weinmann VENTIlogic LS Instructions For Use Manual page 56

The setting can be set in both standby and in ventilation mode. To do so, proceed as
follows.
Note:
• The therapy device automatically starts in softstart mode if this was activated the
last time it was used.
• The softstart function can be switched on or off at any time by briefly pressing
the softstart key
5.9 Set VENTIclick humidifier
(only leakage ventilation)
With the VENTIclick humidifier (only with leakage ventilation), you can humidify the
respiratory air provided by the therapy device. Heating output can be selected in 6 stages.
The setting can be set in both standby and in ventilation mode. To do so, proceed as follows.
56 EN
Operation
1. Keep the softstart key
Softstart window appears.
2. Change the softstart time using the dial (turn to the
right = increase time, turn to the left = reduce time).
Alternatively, you can also increase the softstart time
in 5-minute increments by pressing the softstart key
several times (once the maximum time has been
reached, the device starts back at the minimum time
of 5 minutes if you press again).
3. To save the softstart time, press the menu key
the dial.
The softstart time displayed is saved and the softstart
window closes automatically. If no key is pressed for 4
seconds, the softstart time displayed is likewise saved.
The settings are retained after the device is switched off.
.
1. Press the humidifier key
the Humidifier level window appears. Change the
heating output (stages 1-6) of the humidifier using the
dial or repeatedly press the
2. Press the menu key
output. The Humidifier level window closes
automatically. If no key is pressed for 4 seconds, the
heating output displayed is likewise saved. The
settings are retained after the device is switched off.
depressed until the
for approx. 3 seconds until
key.
or the dial to store the heating
or