Weinmann VENTIlogic LS Instructions For Use Manual page 39

Caution!
The patient valve may not be covered when the device is in operation, otherwise
the exhaled air may not be routed away, obstructing breathing.
Proceed as follows to connect the single patient circuit to the therapy device.
2
3
4
1
4
3
4.3.2 Double patient circuit (VENTIlogic LS only)
In addition to the ventilation tube which delivers air to the patient, the pressure-
measurement tube and the valve control tube, the double patient circuit also has an
exhalation tube which routes exhaled air back to the device and into the ambient air.
On the double patient circuit, the patient valve is located on the exhalation tube.
Proceed as follows to connect up the double patient circuit.
2 1
5
4
3
1. Plug the free end of the ventilation tube (2) onto the
1
device outlet port.
2. Now connect the blue connector stub of the pressure-
measurement tube (1) to the connection of the device
which is likewise blue and marked
3. Connect the valve control tube (3) to the connection
of the device marked
4. Connect the patient valve (4) to the patient/ventilator
2
interface, e.g. a mask.
It is essential to follow the instructions for use of the
patient/ventilator interface and of the patient circuit.
1. Plug the ventilation tube (1) onto the device outlet
port of the VENTIlogic LS.
2. Plug the exhalation tube (3), on the end of which is the
patient valve (4), onto the device inlet port for exhaled
air underneath the device outlet port.
3. Now connect the blue connector stub of the pressure-
measurement tube (2) to the connection of the device
which is likewise blue and marked
.
P
.
P .
EN
Set up device
39