Patient/Ventilator Interfaces - Weinmann VENTIlogic LS Instructions For Use Manual

Caution!
Do not cover the device with blankets etc. The air inlet would be blocked and the
device could overheat. This may lead to inadequate therapy and to damage to the
device.
Cable-securing clip
Now leave the device connected to the power supply for at least 24 hours to charge the
internal battery.
The device is now operational.

4.2 Patient/ventilator interfaces

The therapy device is intended for operation with nasal masks, oronasal masks and full-face
masks as well as with endotracheal cannulas and endotracheal tubes. It is essential to
follow the instructions for use of the patient/ventilator interface in question.
4.3 Connect valve ventilation
When using valve ventilation, patient/ventilator interfaces with leakage openings may not
be used. Always use a patient valve. Inspiration and exhalation is controlled using the
patient valve.
4.3.1 Single patient circuit
The single patient circuit consists of a ventilation tube, a pressure-measurement tube, a
valve control tube and a patient valve. The patient/ventilator interface must be connected
directly to the patient valve.
38 EN
Set up device
1. Connect the power cord to the power connector of
the device.
To do this, lift the cable-securing clip, plug the plug
into the power connector and flip the cable-securing
clip over the plug. Always secure the power plug with
the cable-securing clip to prevent the plug being
removed by mistake.
2. Connect the power cord to a power supply socket.
The therapy device is designed for a supply voltage of
115 V ~ and 230 V ~.
The green LED for power supply comes on and the
start screen appears in the display.