Weinmann VENTIlogic LS Instructions For Use Manual page 62

– ratio of spontaneous inspiration to total number of inspirations in %
– ratio of spontaneous exhalation to total number of exhalations in %
– number of effort episodes, related to number of breaths (TA mode only)
– number of fighting episodes, related to number of breaths (TA mode only)
– tidal volume of last inspiration in ml
– mean respiratory minute volume in ml/min
– current physiological alarms
– current technical alarms
– current warnings
This data can be read out from the memory card and displayed with the aid of
WEINMANNsupport.
If a card is in the device and therapy data is being recorded, a
status line. If the symbol does not appear, the memory card is defective, absent or not yet
recognized by the device.
Caution!
The device must be on standby or switched off for the MMC or SD card to be
inserted or removed, otherwise therapy data may be lost.
Note
The SD card can only be detected by the device when ventilation mode is running.
After inserting the memory card, run the device briefly until the SD card is detected
and the symbol
Proceed as follows to remove the memory card.
62 EN
Operation
is displayed in the status line.
1. The slot for the memory card is located on the side of
the device under a rubber cover. Pull on the rubber
cover to get at the memory card.
2. To remove the memory card, press briefly on the
memory card in the device. A spring mechanism now
pushes the memory card out a little way.
3. Remove the memory card.
4. Cover the slot for the memory card again using the
rubber cover.
symbol appears in the