Overview - Weinmann VENTIlogic LS Instructions For Use Manual

5.6.1 Activate/deactivate plateau signal

5.7 Overview

5.8 Set softstart
(in CPAP mode only)
If your doctor has enabled the softstart function for you, softstart time can be selected in
5-minute increments up to a maximum time of 30 minutes. Your doctor may limit the
maximum time to less than 30 minutes.
Note:
The softstart function is only available in CPAP mode.
In patient mode you can switch the plateau signal on or
off under LIAM info:
1. In the LIAM info menu, use the dial to select the
plateau signal.
2. Confirm your selection by pressing the dial.
3. Use the dial to select the status plateau signal on
or plateau signal off
4. Confirm your selection by pressing the dial.
Under the menu item Displays > Summary you can
have the current Settings, Actual values and Alarms
displayed.
1. In the Patient menu, use the dial to select the
Summary menu item.
2. Confirm your selection by pressing the dial.
3. Use the dial to select the desired submenu.
4. Confirm your selection by pressing the dial.
.
EN
Operation
55