Bandwidth Control - D-Link DGS-3700-12 User Manual

Bandwidth Control

The Bandwidth Control section includes Bandwidth Control Settings and Queue Bandwidth Control Settings.
Bandwidth Control Settings
The bandwidth control settings are used to place a ceiling on the transmitting and receiving data rates for any selected
port.
To view this window, click QoS > Bandwidth Control > Bandwidth Control Settings, as shown below:
The following parameters can be set or are displayed:
Parameter Description
From Port /To Port A consecutive group of ports may be configured starting with the selected port.
Type This drop-down menu allows you to select among RX (receive), TX (transmit), and Both. This
setting will determine whether the bandwidth ceiling is applied to receiving, transmitting, or both
receiving and transmitting packets.
No Limit This drop-down menu allows you to select Enabled or Disabled to specify whether the selected
port have unlimited bandwidth.
Rate (64-1024000) This field allows you to enter the data rate, in Kbits per second, which will be the limit for the
selected port.
Click Apply to set the bandwidth control for the selected ports. Results of configured Bandwidth Settings will be
displayed in the Bandwidth Control Table on the lower half of the window.
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 6- 5 Bandwidth Control Settings window
153