Compound Authentication - D-Link DGS-3700-12 User Manual

Original RX VID
State
VID
Assigned Priority
Aging Time/Block
Time
Idle Time
Click Apply to implement changes.
NOTE: The subnet of the IP address of the authentication VLAN must be the same as that of
the client, or the client will always be denied authentication.
NOTE: A successful authentication should direct the client to the stated web page. If the client
does not reach this web page, yet does not receive a Fail! message, the client will already be
authenticated and therefore should refresh the current browser window or attempt to open a
different web page.

Compound Authentication

Modern networks employ many authentication methods. The Compound Authentication methods supported by this
Switch include 802.1X, MAC-based Access Control (MBAC), Web-based Access Control (WAC), and IP-MAC-Port
Binding (IMPB). The Compound Authentication feature allows clients running different authentication methods to
connect to the network using the same switch port.
The Compound Authentication feature can be implemented using one of the following modes:
Any (MAC, 802.1X or WAC) Mode
In the diagram above the Switch port has been
configured to allow clients to authenticate using 802.1X,
MBAC, or WAC. When a client tries to connect to the
network, the Switch will try to authenticate the client
using one of these methods and If the client passes, it
will be granted access to the network.
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Display the VID from which the user being authenticated originated.
Display the state of WAC authentication.
Display the assigned VLAN.
Display the assigned priority.
Display the aging time period during which an authenticated host will remain in the
authenticated state. The value is between 0 and 1440 minutes. A value of 0 indicates the
authenticated host will never age out on the port. The default value is 1440 minutes (24
hours). The block time parameter is the period of time a host will be blocked if it fails to pass
authentication. The value is between 0 and 300 seconds. The default value is 60 seconds.
Display the idle time.
223