This window allows you to set the following features:
Parameter
Description
Authentication
The Authentication Mode allows the user to choose among, Disabled, Port Based or MAC
Mode
Based Authentication Mode. When choosing MAC Based, Host-based Network Access Control
will be enabled on the port.
Authentication
Choose the Authentication Protocol either RADIUS EAP or Local.
Protocol
Forward EAPOL
This indicates if the Switch forward EAPOL PDU packet, when 802.1X state is globally disabled.
PDU
Max User
Specify the maximum number of users that can be authenticated via 802.1X authentication.
(1-1536)
RADIUS
Choose Enabled to enable RADIUS Authentication or Disabled to disable RADIUS
Authentication
authentication.
Click Apply to implement your configuration changes.
802.1X Port Settings
This window is used to configure the 802.1X Port Settings.
To view this window, click Security > 802.1X > 802.1X Port Settings as shown below:
This window allows you to set the following features:
Parameter
From Port /To Port
QuietPeriod
(0-65535)
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 8- 10 802.1X Port Settings window
Description
Enter the port or ports to be set.
This allows you to set the number of seconds that the Switch remains in the quiet state
following a failed authentication exchange with the client. The default setting is 60 seconds.
201