Application Authentication Settings - D-Link DGS-3700-12 User Manual

Application Authentication Settings

This window is used to configure switch configuration applications (console, Telnet, SSH, web) for login at the user
level and at the administration level (Enable Admin) utilizing a previously configured method list.
To view this window, click Security > Access Authentication Control > Application Authentication Settings, as
shown below:
The following parameters can be set:
Parameter
Application
Login Method List
Enable Method List
Click Apply to implement changes made.
Authentication Server Group Settings
This window will allow users to set up Authentication Server Groups on the Switch. A server group is a technique used
to group TACACS/XTACACS/TACACS+/RADIUS server hosts into user-defined categories for authentication using
method lists. The user may define the type of server group by protocol or by previously defined server group. The
Switch has three built-in Authentication Server Groups that cannot be removed but can be modified. Up to eight
authentication server hosts may be added to any particular group.
To view this window, click Security > Access Authentication Control > Authentication Server Group Settings, as
shown below:
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 8- 47 Application Authentication Settings window
Description
Lists the configuration applications on the Switch. The user may configure the Login Method
List and Enable Method List for authentication for users utilizing the Console (Command Line
Interface) application, the Telnet application, SSH, and the WEB (HTTP) application.
Using the pull-down menu, configure an application for normal login on the user level, utilizing
a previously configured method list. The user may use the default Method List or other
Method List configured by the user. See the Login Method Lists window, in this section, for
more information.
Using the pull-down menu, configure an application for normal login on the user level, utilizing
a previously configured method list. The user may use the default Method List or other
Method List configured by the user. See the Enable Method Lists window, in this section, for
more information
235