D-Link DGS-3700-12 User Manual page 186

The window shown below is the Add CPU ACL Profile window for IPv6.
The following parameters may be configured for the IPv6 filter.
Parameter
Profile ID
Select ACL Type
IPv6 Class
IPv6 Flow Label
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 7- 33 CPU Access Profile Detail Information window (IPv4)
Figure 7- 34 Add CPU ACL Profile window (IPv6)
Description
This value can be set from 1 to 5.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet
content mask. This will change the window according to the requirements for the type of
profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
Select IPv4 to instruct the Switch to examine the IPv4 address in each frame's header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content Mask to specify a mask to check the content of the packet header.
Ticking this check box will instruct the Switch to examine the class field of the IPv6 header.
This class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Ticking this check box will instruct the Switch to examine the flow label field of the IPv6
header. This flow label field is used by a source to label sequences of packets such as non-
default quality of service or real time service packets.
184