Web Pages - D-Link DGS-3700-12 User Manual

Web Pages

When you connect to the management mode of the Switch with a web browser, a login window is displayed. Enter a
user name and password to access the Switch's management mode.
Below is a list and description of the main folders and windows available in the Web interface:
System Configuration – System Information Settings, Dual Configuration Settings, Firmware Information Settings,
Port Configuration, Serial Port Settings, Warning Temperature Settings, System Log Configuration, Time Range
Settings, Time Settings, and User Accounts Settings.
Management – ARP, IPv6 Neighbor Settings, IP Interace, Management Settings, Out of Band Management
Settings, Session Table, Single IP Management, SNMP Settings, Telnet Settings, and Web Settings.
L2 Features – VLAN, QinQ, Layer 2 Protocol Tunneling Settings, Spanning Tree, Link Aggregation, FDB, L2
Multicast Control, ERPS Settings, Local Loopback Port Settings, and LLDP
L3 Features – IPv4 Static/Default Route Settings, IPv4 Route Table, IPv6 Static Default Route Settings, IPv6 Route
Table, and IP Forwarding Table.
QoS – 802.1p Settings, Bandwidth Control, Traffic Control Settings, DSCP, HOL Blocking Prevention, Sceduling
Settings, Management Packet Priority Settings, and SRED.
ACL – ACL Configuration Wizard, Access Profile List, CPU Access Profile List, ACL Finder, and ACL Flow Meter.
Security – 802.1X, RADIUS, IP-MAC-Port Binding (MPB), MAC-based Access Control, Web-based Access Control
(WAC), Compound Authentication, Port Security, BPDU Attack Protection, Loopback Detection Settings, Traffic
Segmentation Settings, NetBIOS Filtering Settings, DHCP Server Screening, Access Authentication Control, SSL
Settings, SSH, Trusted Host Settings, and Safeguard Engine Settings.
Network Application – DHCP, DNS, and SNTP Settings.
OAM – CFM, Ethernet OAM, DULD Settings, and Cable Diagnostics.
Monitoring – Utilization, Statistics, Mirror, sFlow, Ping Test, Trace Route, and Peripheral.
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
NOTICE: Any changes made to the Switch configuration during the
current session must be saved in the Save Changes window (explained
below) or use the command line interface (CLI) command save.
NOTE: Be sure to configure the user name and password in the User
Accounts window before connecting the Switch to the greater network.
14