Sflow Counter Poller Settings - D-Link DGS-3700-12 User Manual

sFlow Counter Poller Settings

This window is used to create the sflow counter poller settings on the Switch. Within the sflow counter poller function,
the port statistics counter information will be forwarded to the server at the configured interval. These counters are
RFC 2233 counters.
To view this window, click Monitoring > sFlow > sFlow Counter Poller Settings, as shown below:
The following parameters can be configured:
Parameter
From Port /To Port
Analyzer Server ID
(1-4)
Interval (20-120)
Click Apply to implement the changes made.
Ping Test
Ping is a small program that sends ICMP Echo packets to the IPv6 or IPv4 address you specify. The destination node
then responds to or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the
Switch and other nodes on the network.
To view this window, click Monitoring > Ping Test, as shown below:
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 11- 25 sFlow Counter Poller Settings window
Description
Specifies the port or list of ports to be configured.
The analyzer server id specifies the ID of a server analyzer where the packet will be
forwarded.
Specifies the maximum number of seconds between successive statistic counter information.
To disable the interval tick the Disabled check box.
Figure 11- 26 Ping Test window
300