The following parameters can be set:
Parameter
System Log
Save Mode
Minutes (1-65535)
To add a new entry, enter the appropriate information and click Apply.
System Log Server Settings
The Switch can send Syslog messages to up to four designated servers using the System Log Server.
To view this window, click System Configuration > System Log Configuration > System Log Server Settings, as
shown below:
The following parameters can be set:
Parameter
Server ID
Server IPv4
Address
Server IPv6
Address
UDP Port
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 2- 18 System Log Settings window
Description
To activate the System Log select Enabled or Disabled.
Use this drop-down menu to specify the method that will trigger a log entry. You can choose
between On Demand, Time Interval and Log Trigger.
On Demand – This method will only save log files when they manually tell the Switch to do so,
using the Save Log link in the Save folder.
Time Interval – This method configures a time interval by which the Switch will save the log
files. The user may set a time between 1 and 65535 minutes.
Log Trigger – This method will save log files to the Switch every time a log event occurs on the
Switch.
Enter a time interval, in minutes, for which you would like a log entry to be made.
Figure 2- 19 System Log Server Settings window
Description
Syslog server settings index (1-4).
Enter the IPv4 address for the Syslog server.
Enter the IPv6 address of the Syslog server.
Type the UDP port number used for sending Syslog messages. The default is 514.
27