D-Link DGS-3700-12 User Manual page 170

802.1p (0-7) Enter a value from 0 to 7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Action Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile are not forwarded by the Switch
and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined
in the config mirror port command. Port Mirroring must be enabled and a target port must be set.
Priority Enter a priority value if you want to re-write the 802.1p default priority of a packet to the value
entered in the Priority field, which meets the criteria specified previously in this command, before
forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming 802.1p
user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Replace Priority Enter a replace priority manually if you want to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value before being forwarded by the Switch
Replace DSCP (0-
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the
63) selected criteria) with the value entered in the adjacent field.
Replace ToS Select this option to instruct the Switch to replace the Type of Service as part of the packet
Precedence header.
Time Range
Tick the check box and enter the name of the Time Range settings that has been previously
Name configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Specifies whether counter feature will be enabled/disabled
Counter
This is optional, the default is disabled.
If the rule is not binded with flow_meter, then all packet matched will be countered.
If the rule is binded with flow_meter, then "counter" here will be overridden.
Ports Specifies the access rule will take effect on one port or a range of ports.
VLAN Name
Specifies the access rule will take effect on the VLAN Name specified.
VLAN ID Specifies the access rule will take effect on the VLAN ID specified.
Click Apply to display the following Access Rule List window.
To view configurations for previously configured rules, click on the corresponding Show Details button, which will
display the following Access Rule Detail Information window:
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 7- 9 Access Rule List window (Ethernet)
168