Upload Log File - D-Link DGS-3700-12 User Manual

Upload Log File

The following window is used to upload a log file for the Switch.
To view this window, click Tools > Upload Log File, as shown below:
To upload a history or attack log from the Switch to a TFTP server, enter a Server IP address, and file/path name and
then click Upload or Upload Attack Log.
To upload either a common log or an attack log by HTTP, click the desired Log Type in the bottom half of the window
and then click Upload.
Reset
The Reset function has several options when resetting the Switch. Some of the current configuration parameters can
be retained while resetting all other configuration parameters to their factory defaults.
NOTE: Only the Reset System option will enter the factory default parameters into the Switch's
non-volatile RAM, and then restart the Switch. All other options enter the factory defaults into the
current configuration, but do not save this configuration. Reset System will return the Switch's
configuration to the state it was when it left the factory
NOTE: The serial port's baud rate will not be changed by the reset command. It will not be
restored to the factory default setting.
Reset gives the option of retaining the Switch's User Accounts and History Log while resetting all other configuration
parameters to their factory defaults. If the Switch is reset using this window, and Save Changes is not executed, the
Switch will return to the last saved configuration when rebooted.
To view this window, click Tools > Reset, as shown below:
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 12- 6 Upload Log File window
Figure 12- 7 Reset System window
306