802.1p User Priority Settings
This window is used to map the 802.1p user priority of an incoming packet to one of the eight hardware queues
available on the Switch.
To view this window, click QoS > 802.1p Settings > 802.1p User Priority, as shown below:
Once you have assigned a priority to the port groups on the Switch, you can then assign this Class to each of the
eight levels of 802.1p priorities. Click Apply to set your changes.
The following parameters can be set or are displayed:
Parameter
Description
From Port/To
A consecutive group of ports may be configured starting with the selected port.
Port
Priority
The 802.1p user priority to associate with the <class_id 0-7> (the number of the hardware
queue) with.
Class ID
The number of the Switch's hardware priority queue. The Switch has eight hardware priority
queues available. They are numbered between 0 (the lowest priority) and 7 (the highest priority).
Click Apply to set the changes.
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 6- 3 802.1p User Priority Settings window
151