D-Link DGS-3700-12 User Manual page 181

The following parameters may be configured for the Packet Content filter.
Parameter
Access ID (1-128)
Action
Priority (0-7)
Replace DSCP
Replace ToS
Precedence
Chunk
Time Range Name
Counter
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 7- 26 Add Access Rule window (Packet Content)
Description
Type in a unique identifier number for this access. This value can be set from 1 to 128.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile to be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the config mirror port command. Port Mirroring must be enabled and a target port
must be set.
Enter a priority value if you want to re-write the 802.1p default priority of a packet to the
value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
its incoming 802.1p user priority re-written to its original value before being forwarded by the
Switch.
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
the selected criteria) with the value entered in the adjacent field.
Select this option to instruct the Switch to replace the Type of Service as part of the packet
header.
This field will instruct the Switch to mask the packet header beginning with the offset value
specified.
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this
access rule will be implemented on the Switch.
Enable or disable the counter settings.
179