D-Link DGS-3700-12 User Manual page 171

To create an IPv4 ACL, select IPv4, enter the Profile ID and Profile Name into the top half of the screen in the Add
ACL Profile window, and click Select. The following window will appear:
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a
new entry, enter the correct information and click Create. To return to the Access Profile List window, click <<Back.
The following parameters can be set for IPv4:
Parameter
VLAN
VLAN Mask (0-FFF)
DSCP
Source IP Mask
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 7- 10 Access Rule Detail Information (Ethernet)
Figure 7- 11 Add ACL Profile window (IPv4)
Description
Selecting this option instructs the Switch to examine the VLAN part of each packet header
and use this as the, or part of the, criterion for forwarding.
Selecting this option and entering a VLAN mask instructs the Switch to examine the VLAN
mask part of each packet header and use this as the, or part of the, criterion for forwarding.
Selecting this option instructs the Switch to examine the DiffServ Code part of each packet
header and use this as the, or part of the, criterion for forwarding.
Enter an IP address mask for the source IP address.
169