Enabling Applications - AudioCodes Mediant 800B User Manual

User's Manual
15

Enabling Applications

The device supports the following main applications:

Stand-Alone Survivability (SAS) application (see SAS Overview on page 491)

Session Border Control (SBC) application (see SBC Overview on page 419)

Cloud Resilience Package (see CRP Overview on page 483)

IP-to-IP application (see IP-to-IP Routing on page 257)
The procedure below describes how to enable these applications. Once an application is
enabled, the Web GUI provides menus and parameter fields relevant to the application.
Notes:

To enable an application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling submenu > Applications Enabling).
2. From the relevant application drop-down list, select Enable.
3. Save (burn) the changes to the device's flash memory with a device reset (see 'Saving
Configuration' on page 530).
Version 6.6

This page displays the application only if the device is installed with the
relevant Software License Key supporting the application (see 'Software
License Key' on page 549).

For enabling an application, a device reset is required.

In some Web pages, the Gateway and IP-to-IP applications are denoted
as "GW" and "IP2IP" respectively.
Figure ‎ 1 5-1: Applications Enabling Page
199
‎ 1 5. Enabling Applications
Mediant 800B GW & E-SBC