AudioCodes Mediant 800B User Manual page 748

Parameter
Web: Max Digits in Phone Num
EMS: Max Digits in Phone
Number
[MaxDigits]
Web: Inter Digit Timeout for
Overlap Dialing [sec]
EMS: Interdigit Timeout (Sec)
[TimeBetweenDigits]
Web: Enable Special Digits
EMS: Use '#' For Dial
Termination
[IsSpecialDigits]
User's Manual
default is two seconds) that can be used when a specific rule is
defined after a more general rule. For example, if the digit map
is 99|998, then the digit collection is terminated after the first two
9 digits are received. Therefore, the second rule of 998 can
never be matched. But when the digit map is 99s|998, then after
dialing the first two 9 digits, the device waits another two
seconds within which the caller can enter the digit 8.
An example of a digit map is shown below:
11xS|00T|[1-7]xxx|8xxxxxxx|#xxxxxxx|*xx|91xxxxxxxxxx|9011x.T
In the example above, the last rule can apply to International
numbers: 9 for dialing tone, 011 Country Code, and then any
number of digits for the local number ('x.').
Notes:

For ISDN interfaces, the digit map mechanism is applicable only
when ISDN overlap dialing is used (ISDNRxOverlap is set to 1).

If the DialPlanIndex parameter is configured (to select a Dial
Plan index), then the device first attempts to locate a matching
digit pattern in the Dial Plan file, and if not found, then attempts
to locate a matching digit pattern in the Digit Map rules
configured by the DigitMapping parameter.

For more information on digit mapping, see 'Digit Mapping' on
page 346.
Defines the maximum number of collected destination number
digits that can be received (i.e., dialed) from the Tel side (analog)
when Tel-to-IP ISDN overlap dialing is performed (digital). When
the number of collected digits reaches this maximum, the device
uses these digits for the called destination number.
The valid range is 1 to 49. The default is 5 for analog and 30for
digital.
Notes:

Instead of using this parameter, Digit Mapping rules can be
configured.

Dialing ends when any of the following scenarios occur:

Maximum number of digits is dialed

Interdigit Timeout (TimeBetweenDigits) expires

Pound (#) key is pressed

Digit map pattern is matched
For analog interfaces: Defines the time (in seconds) that the device
waits between digits that are dialed by the user.
For ISDN overlap dialing: Defines the time (in seconds) that the
device waits between digits that are received from the PSTN or IP
during overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Determines whether the asterisk (*) and pound (#) digits can be
used in DTMF.

[0] Disable = Use '*' or '#' to terminate number collection (refer
to the parameter UseDigitForSpecialDTMF). (Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Note: These symbols can always be used as the first digit of a
748
Mediant 800B GW & E-SBC
Description
Document #: LTRT-10274