Configuring Snmp Trap Destinations - AudioCodes Mediant 800B User Manual

Table ‎ 6 -1: SNMP Community String Parameters Description
Parameter
Community String
Trap Community String
[SNMPTrapCommunityString]
6.2

Configuring SNMP Trap Destinations

The SNMP Trap Destinations page allows you to configure up to five SNMP trap
managers. You can associate a trap destination with SNMPv2 users and specific SNMPv3
users. Associating a trap destination with SNMPv3 users sends encrypted and
authenticated traps to the SNMPv3 destination. By default, traps are sent unencrypted
using SNMPv2.

To configure SNMP trap destinations:
1. Open the SNMP Trap Destinations page (Configuration tab > System menu >
Management submenu > SNMP > SNMP Trap Destinations).
2. Configure the SNMP trap manager parameters according to the table below.
3. Select the check box corresponding to the SNMP Manager that you wish to enable.
4. Click Submit to apply your changes.
Note:
Table ‎ 6 -2: SNMP Trap Destinations Parameters Description
Parameter
Web: SNMP Manager
User's Manual

Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.

Read / Write [SNMPReadWriteCommunityString_x]: Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
Figure ‎ 6 -1: SNMP Trap Destinations Page
Only row entries whose corresponding check boxes are selected are applied
when clicking Submit; otherwise, settings revert to their defaults.
Enables the SNMP Manager to receive traps and checks
the validity of the configured destination (IP address and
Description
Description
78
Mediant 800B GW & E-SBC
Document #: LTRT-10274