Configuration Commands - AudioCodes Mediant 800B User Manual

User's Manual
5.4.5

Configuration Commands

The commands under the CONFiguration directory query and modify the current device
configuration. The following commands are available:
Command
SetConfigParam IP
RestoreFactorySettings /conf/rfs
SaveAndRestart
ConfigFile
5.4.6 PSTN Commands
The commands under the PSTN directory allow you to perform various PSTN actions.
Command
PstnLoopCommands PS/PH/PLC
PstnSendAlarm
Version 6.6
Table 20: Configuration CLI Commands
Short Arguments
Format
/conf/scp ip ip-addr subnet def-
gw
/conf/sar
/conf/cf view | get | set
Table 21: PSTN CLI Command
Short Arguments
Format
<TrunkId>
<LoopCode>
<BChannel>
PS/PH/PSA <TrunkId>
<AlarmSendCode>
Sets the IP address, subnet mask,
and default gateway address of the
device (on-the-fly).
Note: This command may cause
disruption of service. The CLI session
may disconnect since the device
changes its IP address.
Restores all parameters to factory
settings.
Saves all current configurations to the
non-volatile memory and resets the
device.
Retrieves the full ini file from the
device and allows loading a new ini
file directly in the CLI session.
Note: The argument view displays the
file, page by page. The argument get
displays the file without breaks.
Activates a loopback on a specific trunk
and B-channel. For loopback on the
entire trunk, set BChannel=(-1).
The valid value options for LoopCode
include the following:

0 = NO_LOOPS

1 = REMOTE_LOOP (whole trunk
only)

2 = LINE_PAYLOAD_LOOP (whole
trunk only)

3 = LOCAL_ALL_CHANNELS_LOOP
(whole trunk only)
Sends an alarm signal at the Tx interface
or on a specific Trunk ID. The valid value
options for AlarmSendCode include the
75
‎ 5 . CLI-Based Management
Description
Description
Mediant 800B GW & E-SBC