Sas Configuration - AudioCodes Mediant 800B User Manual

User's Manual
32

SAS Configuration

SAS supports various configuration possibilities, depending on how the device is deployed
in the network and the network architecture requirements. This section provides step-by-
step procedures on configuring the SAS application, using the device's Web interface.
The SAS configuration includes the following:

General SAS configuration that is common to all SAS deployment types (see 'General
SAS Configuration' on page 499)

SAS outbound mode (see 'Configuring SAS Outbound Mode' on page 502)

SAS redundant mode (see 'Configuring SAS Redundant Mode' on page 502)

Gateway and SAS applications deployed together (see 'Configuring Gateway
Application with SAS' on page 503)

Optional, advanced SAS features (see 'Advanced SAS Configuration' on page 506)
32.1 General SAS Configuration
This section describes the general configuration required for the SAS application. This
configuration is applicable to all SAS modes.
32.1.1 Enabling the SAS Application
Before you can configure SAS, you need to enable the SAS application on the device.
Once enabled, the SAS menu and related pages appear in the device's Web interface.
Note:

To enable the SAS application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
2. From the 'SAS Application' drop-down list, select Enable.
3. Click Submit.
4. Save the changes to the flash memory with a device reset.
32.1.2 Configuring Common SAS Parameters
The procedure below describes how to configure SAS settings that are common to all SAS
modes. This includes various SAS parameters as well as configuring the Proxy Set for the
SAS proxy (if required). The SAS Proxy Set ID defines the address of the UAs' external
proxy.
Version 6.6
The SAS application is available only if the device is installed with the SAS
Software License Key. If your device is not installed with the SAS feature,
contact your AudioCodes representative.
499
‎ 3 2. SAS Configuration
Mediant 800B GW & E-SBC