AudioCodes Mediant 800B User Manual page 210

Parameter
SRD
[IPGroup_SRD]
Media Realm Name
[IPGroup_MediaRealm]
IP Profile ID
[IPGroup_ProfileId]
Gateway Parameters
Always Use Route Table
[IPGroup_AlwaysUseRoute
Table]
Routing Mode
[IPGroup_RoutingMode]
User's Manual
Assigns an SRD to the IP Group.
The default is 0.
Notes:

For this parameter to take effect, a device reset is required.

To configure SRDs, see Configuring SRD Table on page 201.

For Server-type IP Groups, if you assign the IP Group with a Proxy
Set ID (in the 'Proxy Set ID' field), the SRD field is automatically set
to the SRD value assigned to the Proxy Set in the Proxy Set table.
Assigns a Media Realm to the IP Group. The string value must be
identical (including case-sensitive) to the Media Realm name defined
in the Media Realm table.
Notes:

For this parameter to take effect, a device reset is required.

If the Media Realm is later deleted from the Media Realm table,
then this value becomes invalid.

For configuring Media Realms, see Configuring Media Realms on
page 170.
Assigns an IP Profile to the IP Group.
The default is 0.
Note: To configure IP Profiles, see 'Configuring IP Profiles' on page
243.
Defines the Request-URI host name in outgoing INVITE messages.

[0] No (default).

[1] Yes = The device uses the IP address (or domain name)
defined in the Outbound IP Routing Table (see Configuring the
Outbound IP Routing Table on page 323) as the Request-URI host
name in outgoing INVITE messages, instead of the value
configured in the 'SIP Group Name' field.
Note: This parameter is applicable only to Server-type IP Groups.
Defines the routing mode for outgoing SIP INVITE messages.

[-1] Not Configured = (Default) The routing is according to the
selected Serving IP Group. If no Serving IP Group is selected, the
device routes the call according to the Outbound IP Routing Table
(see Configuring Outbound IP Routing Table on page 323).

[0] Routing Table = The device routes the call according to the
Outbound IP Routing Table.

[1] Serving IP Group = The device sends the SIP INVITE to the
selected Serving IP Group. If no Serving IP Group is selected, the
default IP Group is used. If the Proxy server(s) associated with the
destination IP Group is not alive, the device uses the Outbound IP
Routing Table (if the parameter IsFallbackUsed is set 1, i.e.,
fallback enabled - see 'Configuring Proxy and Registration
Parameters' on page 224).

[2] Request-URI = The device sends the SIP INVITE to the IP
address according to the received SIP Request-URI host name.
Notes:

This parameter is applicable only to the IP-to-IP application.

This parameter is applicable only to Server-type IP Groups.
210
Mediant 800B GW & E-SBC
Description
Document #: LTRT-10274