AudioCodes Mediant 800B User Manual page 246

Parameter
Web: Profile Preference
[IpProfile_IpPreference]
Web: Coder Group
[IpProfile_CodersGroupID]
Web: Remote RTP Base UDP
Port
[IpProfile_RemoteBaseUDPPort
]
Web: First Tx DTMF Option
[IpProfile_FirstTxDtmfOption]
Web: Second Tx DTMF Option
[IpProfile_SecondTxDtmfOption
]
Web: Declare RFC 2833 in SDP
[IpProfile_RxDTMFOption]
Web: Add IE In SETUP
[IpProfile_AddIEInSetup]
Web: Enable QSIG Tunneling
[IpProfile_EnableQSIGTunnelin
g]
Web: Enable Hold
[IpProfile_EnableHold]
[IpProfile_EnableEarly183]
[IpProfile_EarlyAnswerTimeout]
SBC Parameters
Web: Transcoding Mode
[IpProfile_TranscodingMode]
Web: Extension Coders Group ID
[IpProfile_SBCExtensionCoders
GroupID]
User's Manual
Defines the priority of the IP Profile, where "1" is the lowest and
"20" the highest. If both IP and Tel Profiles apply to the same
call, the coders and other common parameters of the preferred
profile are applied to the call. If the preference of the Tel and IP
Profiles is identical, the Tel Profile parameters are applied.
Note: If the coder lists of both IP and Tel Profiles apply to the
same call, only the coders common to both are used. The order
of the coders is determined by the preference.
For a description, see the global parameter CodersGroup.
For a description, see the global parameter
RemoteBaseUDPPort.
For a description, see the global parameter TxDTMFOption.
For a description, see the global parameter TxDTMFOption.
For a description, see the global parameter RxDTMFOption.
For a description, see the global parameter AddIEinSetup.
For a description, see the global parameter
EnableQSIGTunneling.
For a description, see the global parameter EnableHold.
For a description, see the global parameter EnableEarly183.
For a description, see the global parameter
EarlyAnswerTimeout.
For a description, see the global parameter TranscodingMode.
Defines the Coder Group ID used for Extended (additional)
coders added to the outgoing leg for this profile. This is used
when transcoding is required between two IP entities (i.e., the
SDP answer from one doesn't include any coder included in the
offer previously sent by the other). Therefore, to allow IP
entities to communicate with each other regardless of their
capabilities, an Extended coders table with at least one coder
that is supported by each IP entity needs to be assigned to
each IP Group. Therefore, each offer destined to specific IP
Groups includes this coder.
Note: To configure Coders Groups, see Configuring Coder
Groups.
246
Mediant 800B GW & E-SBC
Description
Document #: LTRT-10274