AudioCodes Mediant 800B User Manual page 804

Parameter
[UserToUserHeaderFormat]
Web/EMS: Remove CLI when
Restricted
[RemoveCLIWhenRestricted]
Web/EMS: Remove Calling
Name
[RemoveCallingName]
Web: Remove Calling Name
EMS: Remove Calling Name
For Trunk Mode
[RemoveCallingNameForTrun
User's Manual
From:<sip:2000;cpc=payphone@10.8.23.70>;tag=1c18
06157451
Note: This feature is applicable only to the NI-2 PRI variant.
Defines the interworking between the SIP INVITE's User-to-User
header and the ISDN User-to-User (UU) IE data.

[0] = (Default) SIP header format: X-UserToUser.

[1] = SIP header format: User-to-User with Protocol
Discriminator (pd) attribute (according to IETF Internet-Draft
draft-johnston-sipping-cc-uui-04). For example:
User-to-
User=3030373435313734313635353b313233343b3834;pd
=4

[2] = SIP header format: User-to-User with encoding=hex at the
end and pd embedded as the first byte (according to IETF
Internet-Draft draft-johnston-sipping-cc-uui-03). For example:
User-to-
User=043030373435313734313635353b313233343b3834;
encoding=hex
where "04" at the beginning of this message is the pd.

[3] = Interworks the SIP User-to-User header containing text
format to ISDN UUIE in hexadecimal format, and vice versa. For
example:
SIP Header in text format:
User-to-User=01800213027b712a;NULL;4582166;
Translated to hexadecimal in the ISDN UUIE:
303138303032313330323762373132613b4e554c4c3b3435
38323136363b
The Protocol Discriminator (pd) used in UUIE is "04" (IUA
characters).
Note: This parameter is applicable for Tel-to-IP and IP-to-Tel calls.
Determines (for IP-to-Tel calls) whether the Calling Number and
Calling Name IEs are removed from the ISDN Setup message if the
presentation is set to Restricted.

[0] No = (Default) IE's are not removed.

[1] Yes = IE's are removed.
Enables the device to remove the Calling Name from SIP-to-ISDN
calls for all trunks.

[0] Disable = (Default) Does not remove Calling Name.

[1] Enable = Removes Calling Name.
Note: Some PSTN switches / PBXs may not be configured to
support the receipt of the "Calling Name" information. These
switches might respond to an ISDN Setup message (including the
Calling Name) with an ISDN
"REQUESTED_FAC_NOT_SUBSCRIBED" failure. This parameter
can be set to Enable (1) to remove the "Calling Name" from SIP-to-
ISDN calls and allow the call to proceed.
Enables the device to remove the Calling Name per trunk for SIP-
to-ISDN calls, per trunk.

[-1] Use Global Parameter = (Default) Settings of the global
parameter RemoveCallingName are used.
804
Mediant 800B GW & E-SBC
Description
Document #: LTRT-10274