AudioCodes Mediant 800B User Manual page 621

User's Manual

To install Wireshark and the plug-ins for debug recording:
1. Install Wireshark on your computer. The Wireshark program can be downloaded from
http://www.wireshark.org.
2. Copy the supplied AudioCodes plug-in files to the directory in which you installed
Wireshark, as follows:
...\dtds\cdr.dtd
...\plugins\1.6.2\*.dll
...\tpncp\tpncp.dat
3. Start Wireshark.
4. In the Filter field, type "acdr" (see the figure below) to view the debug recording
messages. Note that the source IP address of the messages is always the OAMP IP
address of the device.
The device adds the header "AUDIOCODES DEBUG RECORDING" to each debug
recording message, as shown below:
For ISDN trace messages, the additional header, "NetBricks Trace" is added below the
"AUDIOCODES DEBUG RECORDING" header, as shown in the example below:
AUDIOCODES DEBUG RECORDING
NetBricks Trace
System time: 3559
Direction: Message received from internal server queue (73)
From (Entity origination ID): DL_D (DL LAPD Q.921) (100)
To (Entity destination ID): PH_D (D channel physical) (68)
Primitive code: 67
NAI (Network Access ID): 0 -> number of trunk
SAPI: 1
Connection ID: 0
Congestion flag: 0
Allocated message: 2
Allocated buffer: 3
Allocated timer cell: 141
IT Message stack counter: 120
IT Buffer stack counter: 120
Version 6.6
Copy this file
621
‎ 4 6. Syslog and Debug Recordings
To this folder
Wireshark\dtds\
Wireshark\plugins\1.6.2
Wireshark\tpncp
Mediant 800B GW & E-SBC