Cli Commands - AudioCodes Mediant 800B User Manual

4. At the Password prompt, type the password, and then press Enter:
Password: Admin
5. At the prompt, type the following, and then press Enter:
enable
6. At the prompt, type the password again, and then press Enter:
Password: Admin
5.4

CLI Commands

The CLI commands are used mainly to display current configuration and performance.
These commands are organized in subdirectories. When the CLI session starts, you are
located in the 'root' directory.
To access a subdirectory, type its name, and then press Enter. The CLI commands can be
entered in an abbreviated format by typing only the letters shown in upper case (i.e., capital
letters). For example, the CHangePassWord command can be entered by typing chpw. If
you know the full path to a command inside one of the subdirectories, the short format can
be used to run it directly. For example, the PERFormance command in the MGmt
subdirectory may be run directly by typing /mg/perf.
The following table summarizes the basic CLI commands:
Purpose Commands
Help h
Navigation cd
cd root
..
exit
5.4.1 Status Commands
The following table summarizes the Show commands and their corresponding options.
Command Short Format
SHow sh
SHow INFO
sh info
SHow TDM sh tdm
User's Manual
Table 14: Basic CLI Commands
Displays the help for a specific command, action, or parameter.
Enters another directory.
Navigates to the root directory (/).
Goes up one level.
Terminates the CLI session.
Table 15: Show CLI Commands
Arguments
info | tdm | dsp | Displays operational data.
ip | log




- Displays device hardware information,
versions, uptime, temperature reading, and the
last reset reason.
status | perf | Displays the alarm status and performance
summary statistics for E1/T1 trunks.
70
Mediant 800B GW & E-SBC
Description
Description
info: Displays general device information
tdm: Displays PSTN-related information
dsp: Displays DSP resource information
ip: Displays information about IP interfaces
Document #: LTRT-10274