AudioCodes Mediant 800B User Manual page 741

User's Manual
Parameter
Web: Profile Number
EMS: Allocation Profile
[V1501AllocationProfile]
Web/EMS: SSE Payload Type Rx
[V1501SSEPayloadTypeRx]
Web/EMS: SSE Redundancy
Depth
[V1501SSERedundancyDepth]
Web: SPRT Transport Ch.0 Max
Payload Size
[V1501SPRTTransportChannel
0MaxPayloadSize]
Web: SPRT Transport Ch.2 Max
Payload Size
[V1501SPRTTransportChannel
2MaxPayloadSize]
Web: SPRT Transport Ch.2 Max
Window Size
[V1501SPRTTransportChannel
2MaxWindowSize]
Web: SPRT Transport Ch.3 Max
Payload Size
[V1501SPRTTransportChannel
3MaxPayloadSize]
Version 6.6
T.38 packets sent from the termination IP fax, the fax fails.
To overcome this, the device sends No-Op ("no-signal") packets
to open a pinhole in the NAT for the answering fax machine. The
originating fax does not wait for an answer, but immediately starts
sending T.38 packets to the terminating fax machine.
Note: To enable No-Op packet transmission, use the
NoOpEnable and NoOpInterval parameters.
Defines the V.150.1 profile, which determines how many DSP
channels support V.150.1.
The value range is 0 to 20. The default is 0.
Note: For this parameter to take effect, a device reset is required.
Defines the V.150.1 (modem relay protocol) State Signaling
Event (SSE) payload type Rx.
The value range is 96 to 127. The default is 105.
Defines the SSE redundancy depth.
The value range is 1-6. The default is 3.
Defines the maximum payload size for V.150.1 SPRT Transport
Channel 0.
The range is 140 to 256. The default is 140.
Defines the maximum payload size for V.150.1 SPRT Transport
Channel 2.
The range is 132 to 256. The default is 132.
Defines the maximum window size of SPRT transport channel 2.
The value range is 8 to 32. The default is 8.
Defines the maximum payload size for V.150.1 SPRT Transport
Channel 3.
The range is 140 to 256. The default is 140.
741
‎ 5 1. Configuration Parameters Reference
Description
Mediant 800B GW & E-SBC