Enabling Applications - AudioCodes Mediant 2000 User Manual

SIP User's Manual
15

Enabling Applications

The device supports the following main applications:

Stand-Alone Survivability (SAS) application

IP2IP application
The procedure below describes how to enable these applications. Once an application is
enabled, the Web GUI provides menus and parameter fields relevant to the application.
Notes:

To enable an application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling submenu > Applications Enabling).
2. Save the changes to the device's flash memory and then reset the device (see
''Saving Configuration'' on page 350).
Version 6.4
•
This page displays the application only if the device is installed with the
relevant Software Upgrade Key supporting the application (see ''Loading
Software Upgrade Key'' on page 362).
•
For configuring the SAS application, see ''Stand-Alone Survivability
(SAS) Application'' on page 315.
•
For an overview of the IP2IP application and configuration examples, see
IP-to-IP Routing Application on page 294.
•
For enabling an application, a device reset is required.
•
The Gateway and IP-to-IP applications are depicted in the Web interface
as "GW" and "IP2IP" respectively.
197
15. Enabling Applications
November 2011