AudioCodes Mediant 800B User Manual page 865

User's Manual
Parameter
Web: Transcoding Mode
CLI: transcoding-mode
[TranscodingMode]
Web: SBC Preferences Mode
[SBCPreferencesMode]
Web: SBC Send Invite To All
Contacts
CLI: sbc-send-invite-to-all-
contacts
[SBCSendInviteToAllConta
cts]
Web: SBC Shared Line
Registration Mode
CLI: sbc-shared-line-reg-
mode
[SBCSharedLineRegMode]
Version 6.6
are handled as a No Media Anchoring (direct media) call.
Chosen configuration can't handle call from any UA to a foreign

UA (vice versa) but both UAs belong to the same SRD and the
parameter IntraSRDMediaAnchoring for that specific SRD is > 0.

When this parameter is disabled, No Media Anchoring calls
between two UAs that belong to separate SRDs cannot be
configured. No Media Anchoring calls between two UAs that
belong to the same SRD is configurable only (in this case).
Defines the voice transcoding mode (media negotiation) between
the two SBC legs for the SBC application.

[0] Only if Required = (Default) Do not force transcoding. Many
of the media settings (such as gain control) are not implemented
on the voice stream. The SBC application passes packets RTP
to RTP without any processing.

[1] Force = Forces transcoding on the outgoing SBC leg. The
device's SBC application interworks the media by implementing
DSP transcoding.
Note: This parameter can also be configured in an IP Profile.
Determines the order of the Extension coders (coders added if there
are no common coders between SDP offered coders and Allowed
coders) and Allowed coders (defined in the Allowed Coders Group
table) in the outgoing SIP message (in the SDP).
[0] Doesn't Include Extensions = (Default) Extension coders are

added at the end of the coder list.

[1] Include Extensions = Extension coders and Allowed coders
are arranged according to their order of appearance in the
Allowed Coders Group table.
Note: If the SBCExtensionCodersGroupID parameter of the IP
Profile table is set to None, then this parameter is not applicable.
Enables call forking of INVITE message received with a Request-
URI for a specific contact registered in the device's database, to all
users under the same AOR as the contact.

[0] Disable (default) = Sends the INVITE only to the contact of
the received Request-URI.

[1] Enable
Note: To configure call forking initiated by the device, see Initiating
SIP Call Forking.
Enables the termination on the device of SIP REGISTER messages
from secondary lines pertaining to the Shared Line feature.

[0] Disable = (Default) Device forwards the REGISTER
messages as is (i.e., not terminated on the device).

[1] Enable = REGISTER messages of secondary lines are
terminated on the device.
Note: The device always forwards REGISTER messages of the
primary line.
865
‎ 5 1. Configuration Parameters Reference
Description
Mediant 800B GW & E-SBC