Printer Is Making Unusual Noises; Paper Tray Will Not Close; Condensation Has Formed Inside The Printer - Xerox VersaLink B405 User Manual

Printer is Making Unusual Noises

Probable Causes
There is an obstruction or debris inside the printer.

Paper Tray Will Not Close

Probable Causes
The paper tray does not fully close.

Condensation has Formed Inside the Printer

Moisture can condense inside a printer where the humidity is above 85% or when a cold printer is located
in a warm room. Condensation can form in a printer after it has been sitting in a cold room that is heated
quickly.
Probable Causes
The printer has been sitting in a cold room.
The relative humidity of the room is too high.
® ®
Xerox VersaLink B405 Multifunction Printer
User Guide
Solutions
Power off the printer, then remove the obstruction or
debris. If you cannot remove the obstruction, contact
your Xerox representative.
Solutions
• If the tray is extended for legal-size paper, the tray
protrudes when it is inserted into the printer. For
more information, refer to
for the Paper Length.
• Some debris or an object is blocking the tray.
• The tray is blocked by the table or shelf on which it
is located.
• If the paper lift plate at the back of the tray is not
locked down, replace the tray.
Solutions
Allow the printer to operate for several hours at room
temperature.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature
and relative humidity are within the operating spe-
cifications.
Troubleshooting
Configuring Trays 1 or 2
8-5