VERITAS NetBackup 5330 Appliance Hardware Installation Manual page 38

38 Hardware installation procedures
Installing a Primary Shelf or an Expansion Shelf
6
You can use the flathead screws on the inside of the rail to extend or shorten
it to fit into the rack.
7
You can also use an expansion bracket if you need to reinforce the rear of the
rack.
Use the UP arrow to determine whether the bracket should be attached to the
rear of the left or the right rail.
8
To secure the rail to the rack, do the following:
Place one spacer, each, on two screws. The following illustrations show
■
square and round spacers. Either type of spacer may ship with the storage
shelf.
If you have round spacers insert the raised portion of the spacer into the
■
rack hole from the rack front. The spacer centers the screw for rail
installation. The raised side of the round spacer is shown at the top of the
following picture.